DIYCarpetStretching.com is supported by readers and may earn an affiliate commission.

Rather have a pro do it for you?

Tools and Supplies to Stretch Carpet on Hardwood Floors
1 Carpet kicker
2 Knee kicker
3 Carpet cutter
4 Carpet tape
5 Staple gun
6 Staples
7 Carpet shears
8 Seam roller
9 Carpet stair tool
10 Carpet awl

How to Stretch Carpet on Hardwood Floors

Effortlessly Stretch Your Carpet on Hardwood Floors with These Easy Steps

Stretching carpet on hardwood floors is a task that can be accomplished with the right tools and technique. Here is a step-by-step guide on how to stretch carpet on hardwood floors:

Step 1: Clear the room
The first step in stretching carpet on hardwood floors is to clear the room of all furniture and items. This will give you ample space to work with and prevent any damage to the furniture.

Step 2: Remove baseboards
Next, remove the baseboards from the walls. This will allow you to stretch the carpet all the way to the wall without any obstruction. Use a pry bar to gently remove the baseboards without damaging them.

Step 3: Cut the carpet
Using a carpet cutter or utility knife, cut the carpet along the edges of the room. Make sure to leave a few inches of excess carpet on all sides.

Step 4: Remove the old carpet padding
Remove the old carpet padding from the hardwood floor. Use a scraper or putty knife to remove any remaining adhesive or debris.

Step 5: Install new carpet padding
Install new carpet padding on the hardwood floor. Make sure to cut the padding to fit the room and lay it flat on the floor.

Step 6: Stretch the carpet
Begin stretching the carpet by attaching a power stretcher to the carpet. This tool will allow you to stretch the carpet to the desired tension. Start at one end of the room and work your way towards the opposite end.

Step 7: Trim the excess carpet
Once the carpet is stretched to the desired tension, trim the excess carpet using a carpet cutter or utility knife. Make sure to leave a few inches of excess carpet on all sides.

Step 8: Tuck the carpet
Tuck the excess carpet under the baseboards using a carpet tucker. This will give the carpet a clean and finished look.

Step 9: Install the baseboards
Finally, install the baseboards back onto the walls using a nail gun or hammer and nails. Make sure to nail the baseboards into the wall studs for a secure hold.

In conclusion, stretching carpet on hardwood floors can be a challenging task, but with the right tools and technique, it can be done efficiently and effectively. By following these step-by-step instructions, you can stretch your carpet on hardwood floors with ease.